Breaking Torque Handles TBN ‘Breaking’ Torque Handles

These tools have to be Pre-Set to the required torque value using a calibration analyser or, by using the scale provided on the tool for calibrated models. When the required torque value is achieved during tightening, the tools ‘Breaks’ as a signal to the Operator. This significantly reduces the possibility of over-tightening

Model	End Fitting
			N·m	lbf·in
TBNS 2	8mm Diameter Spigot Type	048800	0.2 - 2.0	1.8 - 18	133	5.24	135	4.8
TBNS 10	8mm Diameter Spigot Type	048900	1.0 - 10	9.0 - 89	133	5.24	135	4.8
TBN 25 E	16mm Diameter Spigot Type	050000	5.0 - 25	44 - 221	265	10.44	405	14.3
TBN 25 EG	9x12 Rectangular Cavity German Type	050010	5.0 - 25	44 - 221	265	10.44	405	14.3
TBN 25 EW	Wedge Type (Dovetail)	050030	5.0 - 25	44 - 221	265	10.44	405	14.3
TBN 65 E	16mm Diameter Spigot Type	050100	10 - 65	89 - 575	302	11.9	750	26.5
TBN 65 EG	9x12 Rectangular Cavity German Type	050110	10 - 65	89 - 575	302	11.9	750	26.5
TBN 65 EW	Wedge Type (Dovetail)	050130	10 - 65	89 - 575	302	11.9	750	26.5
TBN 135 E	16mm Diameter Spigot Type	050200	20 - 135	177 - 1195	408	16.10	1030	36.4
TBN 135 EG	9x12 Rectangular Cavity German Type	050210	20 - 135	177 - 1195	408	16.10	1030	36.4
TBN 135 EW	Wedge Type (Dovetail)	050230	20 - 135	177 - 1195	408	16.10	1030	36.4

The preferred and certified ranges of these tools is in accordance and exceeds the requirements of ISO 6789:2003. (Repeatability ± 4% of reading for tools above 10 Nm and ± 6% of reading for tools less than 10 Nm).

Approved for use in Electrostatic Discharge Protected Areas.